|Place of Origin:||china|
|Minimum Order Quantity:||1|
SuperPro 7100 Gang Programmer On-line/Off-line
It is high-speed FLASH memory production at the industrial level programmer. Highly cost-effective. and Strengthened support for the eMMC, parallel NAND FLASH, serial NAND FLASH, serial FLASH/EEPROM, NOR FLASH devices. Up to 4 parallel programming a chip. 4 can be replaced independently of the adapter. Programming speed is very high. EMMC operating speed than the SP5000 increased nearly 10 times.
Same programming engine with SuperPro/7000.
Ultra-high programming peed. 10 times higher than SuperPro/5000 for eMMC.
Industry grade quality and reliability. IC manufacturer approved programming algorithms.
Supports eMMC, NAND FLASH, NOR FLASH, Serail EEPROM/FLASH/NAND etc. Supports devices with Vcc as low as 1.2V.
Support up to 4 chips in parallel.
Many safety mechanisms are built including self-calibration, self-diagnosis, wrong chip placement detection, poor-pin-contacting detection, ID checking, over-current and over-voltage protection etc.
Triple operation modes for various application requirements.
1)PC hosted mode. The programmer is controlled by PC via USB2.0;
2)Stand-alone mode. The programmer is controlled via a 6-Key keypad and a 20 character by 4 line LCD display. A SD card is used to store the project files.
3)Network mode. With the LAN port it’s an easy job to connect the programmer to LAN or Internet.
Advanced and powerful software functions.